Full View
Liknande föremål
1PC 50MM 44MM 25W High Power Resonance Vibration Shaker Loudspeaker Woofer Bass Drive Plane Speaker Driver Horn For
392,06kr394,38kr
Färg : 44MM-4Ohm 25W Sliver
Fartyg från : Kina (fastland
Kina (fastland
Ryska Federationen
Mängd :
Rapportera
Inkludera upphovsrättsintrångGratis standardfrakt. Se detaljer
Beräknad mellan Fri, Jul 24 och Thu, Jul 30
Du kan returnera produkten inom 30 dagar efter mottagandet. Se detaljer
Handla med självförtroende
Pengarna-tillbaka-garanti
Få varan du beställt eller pengarna tillbaka. Läs mer
About this item
Hämtad från 3C electronics mall
Seller assumes all responsibility for this listing.Artikelnummer: 37711865
Item specifics
Item description from the seller
44MM/50MM vibration Speaker For Diy vibration speaker system
Impedance: 4OHM or 8OHM
Rated Power: 4OHM 25W
Rated Power:8OHM 20W
MAX Power： 30W
Resonance Frequency:60HZ At1.0V
Outerput S.P.L: 86DB +-3dB
Distortion<5% at 1KHz
25mm Voice coil and good bass effect
Frequency Response Curve:FO-20K HZ
Net weight:50MM :268 g , 44MM: 294
44MM No hole on the foot
50MM have 3 hold on the foot
Install instruction:
Just connect the wire to the amplified audio signal. Make sure to put falt aluminum on a plain surface. The sound，especially the bass sound will be generated by the resonance of the speaker and the surface， such as a wooden table.
Make sure the flat aluminum panel face down in a vertical way.
Turn on the amplifier form small to large, and stop if you can get a good sound quality and low distortion. To avoid to load the amplifier to the maximum volume directly.
