Lämplig för främre huven personliga modifieringslampor, ögonbrynsklistermärken, Audi bilklistermärken

【 Craftsmanship 】: Fine carved car stickers 【 Material 】: Reflective material [Color]: Black, White, Grey [Specification]: One sheet 【 Size 】: 50CM * 17.5CM (There may be a 1-3CM error in manual cutting size, please understand if there is any inconvenience) Weight: 20g 【 Scope of application 】: Lamp eyebrow sticker All car stickers in our store are acceptable and do not come with OPP bag packaging. If packaging is required, please contact customer service for consultation instructions: 1、 Firstly, all car stickers in the store are composed of three parts: the layer is a transparent transfer film with moderate adhesion (which needs to be removed after pasting the car sticker), the second layer is the car sticker, and the third layer is the base paper, usually yellow (the materials we use are mainly Weishi Bai A-level reflective film and Taiwan KK car sticker special film). 2、 Due to the fact that the stickers are rolled up during packaging and shipping, bubbles may sometimes appear on the yellow base paper and transfer film. This is a normal phenomenon and will not affect the adhesive effect of the car stickers. Before pasting, place it on a flat tabletop and use a scraper or credit card to flatten it. 3、 Please note: The correct way to remove the car sticker is to first remove the backing paper, rather than directly tearing off the transfer film. When removing the backing paper, it is necessary to operate slowly, and the speed should be such that the car sticker does not stick to the yellow backing paper. 4、 First, determine the location to be pasted, and after cleaning, you can open the sticker: 1. Dry pasting method (applicable for car stickers within 30CM): Compare the angle of the car sticker at the position to be pasted, and after confirming, press and hold the two corners of the left transfer film, scraping while pasting to ensure that there are no bubbles inside the car sticker. After the entire sticker is posted, use a scraper or credit card to scrape the flat sticker. Be careful not to apply too much force here, otherwise it will damage the transfer film and affect the effectiveness of the sticker. 2. Wet pasting method (suitable for large vehicles over 30CM): Use clean water to evenly spray water on the position to be pasted and the car sticker with the bottom paper removed. First, gently apply the sticker, adjust the angle and position, and slowly scrape the water from one side to the other. 5、 After pasting, be careful to remove the transfer film. In winter, you can blow it with a hot air gun (or use a hair dryer) to ensure that the car sticker is completely firmly attached to the car. After completion, try not to wash the car as much as possible, usually for about three days.