Peeking Monster Auto Dune Monster Car Sticker, Peeking Elf Car Sticker

Product introduction: [Brand Manufacturer] Di Di [Product Name] Dune Monster Car Sticker [Product material] Imported reflective material, waterproof, sun protection and high temperature resistance [Product size] 19X7CM [Craft] Engraving [Quality] Professional independent production, quality assurance.   1. Clean the back of the car and spray water with a watering can on the body part to be pasted - mainly to reduce the viscosity of the sticker and facilitate adjustment of the position. 2. After determining the location that needs to be pasted, remove the transfer film (transparent film pasted on the reflective sticker) together with the car sticker from right to left [or from top to bottom] and press it with a rag on the car watch. Then, while pasting, flatten with a rag, and uncover the bottom paper. 3. When encountering door handles or anti-collision strips, the material should be cut open and wrapped or loaded according to the situation. 4. Timely adjustment to determine the general position of the pattern, use a scraper to repeatedly scrape off water and bubbles, and use the scraper to scrape diagonally from right to left; finally tear off the transparent transfer film. 5. When encountering the door and the seam, use a utility knife to cut it evenly and paste it inward. 6. Try to dry the moisture in the car sticker. If possible, you can use a hair dryer to heat and dry moderately. It is recommended that you try not to expose to the sun within 24 hours, and it is not advisable to wash the car within 48 hours.