[ 2 rotationslägen ] FRUCASE PU Watch Winder för automatiska klockor Klockbox kan serialiseras

Introduction to working mode The frucase watch winder has a built-in intelligent chip. In order to protect the watch from over winding, the machine will not run all the time. It will automatically stop and run again. Different modes of operation are different, as follows: Mode B : Clockwise for 2 minutes, stop for 6 minutes, then counterclockwise for 2 minutes, stop for 6 minutes and cycle. Mode L : Clockwise for 2 minutes, stop for 18 minutes, then counterclockwise for 2 minutes, stop for 18 minutes and cycle. When the B / L mode is turned on, it will automatically run and stop, and then run again，The whole process is completed automatically (*TIPS:Please relax, it is not quality issue if you find it doesn’t turning. You need to check if it will start turning several minutes later. Maybe it is resting time when you watch it.) TIPS： (★Please relax, it is not quality issue if you find it doesn’t turning. You need to check if it will start turning several minutes later. Maybe it is resting time when you watch it.★) Working mode introduction Mode B : Clockwise for 2 minutes, stop for 6 minutes, then counterclockwise for 2 minutes, stop for 6 minutes and cycle. Mode L : Clockwise for 2 minutes, stop for 18 minutes, then counterclockwise for 2 minutes, stop for 18 minutes and cycle. NOTE ①Watch winders are not compatible with Seiko Kinetic Watches because the watch mechanism is not the same as traditional automatic movement watches. ②The design of the watch winder has been tested and will not cause harm to your expensive automatic watches due to magnetization. ③For automatic watches to operate properly when using a watch winder, when the watch is containing at least 50% of power reserve prior to being placed on a winder.